Condensed water container
43
Preparing the condensed
water container for the Soft
Steam program
During the Soft Steam program,
the condensed water collected in the
condensed water container is
sprayed into the drum via a spray jet.
The condensed water container must
therefore be filled with water to at
least the –min– marker.
Otherwise, this could cause a fault.
The –min– marker is at the front left-
hand side of the container.
Make use of the condensed water
which collects during the drying
process.
If the condensed water container is
empty
You can fill the condensed water
container with commercially available
condensed water (ironing water).
You should only use tap water in
exceptional circumstances. If tap water
is used frequently, however, the spray
jet (in the door opening) can become
calcified.
1 spout, 2 rubber seal
Pour the water in through the rings of
the spout 1.
Only use clean water. The water
must not contain any fragrance,
detergent, or other substances.
Check the rubber seal from time to
time.
If tap water is used frequently, white
limescale deposits can build up on the
rubber seal 2.
Use a damp cloth to carefully remove
any limescale deposits from the
rubber seal 2.
After cleaning the rubber seal, push
the condensed water container fully
into the dryer.
To Next Page
Loading...
Need help?
General