Miele TWI 180 WP User Manual

Settings
87
Airway indicator
Lint should be removed after drying. In
addition, this indicator will remind you
to clean the filters when a certain
amount of lint has collected in them:
 Clean the lint filter and the plinth filter.
See 
You can decide at what level of lint
this reminder should be given.
Options
You will have an idea of how often this
should be done after a few drying
programs.
– Off
This reminder indicator does not
appear. However, if there is a very
severe blockage in the ducting, the
program will be canceled and the 
Clean the lint filter and the plinth filter. See
 message will appear in the
display regardless of this option.
– Heavy
The indicator only appears when
there is a heavy build-up of lint.
– Normal (default setting)
– Light
The indicator appears when there is
only a small build-up of lint.
Conductivity
This setting is only relevant for regions
with very low water hardness.
You should only select this setting if
the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) less than 150μS/cm.
Contact your local water supplier for
the conductivity level of your mains
water supply.
Otherwise drying results can be
unsatisfactory.
Options
– Normal (default setting)
– Low <150μS (only for regions with
very low water hardness)

Miele TWI 180 WP Specifications

General

Brand	Miele
Model	TWI 180 WP
Category	Washer
Language	English