Settings
90
Miele@home
Control the networking of your dryer
with your WiFi network.
The following points may appear in the
submenu:
Set up
This message only appears if the dryer
has not yet been connected to a WiFi
network.
Please refer to "Initial commissioning"
to set up the connection.
Deactivate (visible if Miele@home is
activated)
Miele@home remains set up, the WiFi
function is switched off.
Activate (visible if Miele@home is
deactivated)
The WiFi function is reactivated.
Connection status (visible if Miele@home
is activated)
The following values are displayed:
– The quality of WiFi reception
– The network name
– The IP address
Set up again (visible if set up)
Resets the WiFi login (network) to
immediately re-establish a new
connection.
Reset (visible if set up)
– The WiFi is switched off.
– The WiFi connection will be reset to
the default setting.
Miele@home is no longer set up. A new
connection setup has to be carried out
in order to use the Miele@home setting
again.
To Next Page
Loading...
Need help?
General