Installation and connection
83
Refitting
7. Refit the door
Press the rubber seal back into the
groove on the door.
Position the door in front of the dryer.
Fit the base of the door hinge with its
2 pins into the openings on the dryer.
The base of the door hinge must be
flush with the front panel of the dryer.
The door cannot fall off in this position.
Screw the door securely to the dryer
at the base of door hinge .
Now that you have changed the door
hinging, the door will open from the
opposite side.
Push the orange marker round to the
other side so that you will see at
which side to pull the door open.
Please keep the lock catch and door
hinge covers which were no longer
needed in a safe place. These will be
required if you choose to change the
door hinging back to its original
position.
To Next Page
Loading...
Need help?
General