Frequently Asked Questions
60
The drying cycle duration is very long.
Problem Possible cause and solution
The drying process
goes on too long or
even switches off.*
The room in which the tumble dryer is located is too
warm.
Ventilate the room thoroughly.
Detergent residues, hair, and fine lint can clog the
filters.
Clean the lint filters and the plinth filter.
Remove visible lint:
. . . on the bottom left, behind the flap in the heat
exchanger cavity (see "Cleaning and care");
. . . at the bottom right of the cooling fins behind
the grille (see the end of this section).
The laundry is unevenly distributed or has rolled up.
The tumble dryer has been overloaded.
Untangle the laundry and remove a few items.
Start a program.
The cool air intake (bottom right grille) is blocked.
Move any objects, such as a laundry basket, away
from the dryer.
The lint filters and the plinth filter were wet when
replaced.
The lint filters and the plinth filter must be dry.
The laundry is too damp.
Spin using a higher spin speed in the washing
machine.
Metallic components, e.g., zippers, have prevented
the dryer from registering the correct moisture level.
Open the zippers next time.
If the problem recurs, dry these items using the
Time Dry timed drying program.
* Switch the tumble dryer off and on again before starting a new program.
To Next Page
Loading...
Need help?
General