Miele TWI 180 WP User Manual

Installation and connection
77
External draining of condensed
water
Note
When drying is in progress,
condensed water is pumped into the
condensed water container through
the drain hose which is located at the
back of the dryer.
The condensed water can also be
externally drained away via the drain
hose on the back of the dryer. This
means that the condensed water
container no longer has to be emptied.
Drain hose length: 5.2ft (1.6m)
Maximum delivery head: 4.9ft (1.5m)
Maximum drain hose length: 13ft
(4m)
Arranging the drain hose
 Do not pull on the drain hose
and do not stretch it or allow it to
become kinked.
This could damage the hose.
There will be a small amount of residual
water left in the drain hose. Have a
container ready to collect this.
 Pull the drain hose off its connection
(light arrow).
 Pull the hose out of the holders (dark
arrow) and unwind it.
 Allow any residual water to run into a
container.
Condensate drain
The drain hose on the back of the dryer
can be inserted into the drainage
mechanism.
 Attach the end of the hose to the
drainage mechanism.
 Secure the drain hose carefully
(e.g., by tying it) to make sure it
cannot slip.
Overflowing water can cause
damage.

Miele TWI 180 WP Specifications

General

Brand	Miele
Model	TWI 180 WP
Category	Washer
Language	English