Mikado LOGO 700 - 7 Tail Boom Mounting; Tail Boom Insertion; Tail Boom Securing Screws; Tail Boom Final Fixation

Bag 8
Push the tail boom all the way into the chassis. Tighten all six
screws holding the tail boom fi rmly, making sure the drilled
holes for the rotation prevention in the tail boom are aligned
properly. Finally fi x the tail boom using the M3x10 hex screws,
from both sides.
Manual LOGO 700 - ©Mikado Model Helicopters GmbH - Page 12
7 Tail Boom Mounting
M3x10
M2,5x8
2x M3x10