Milesight AM308 - Page 2

2
Applicability
This guide is applicable to AM300 series sensors shown as follows, except where otherwise
indicated.
Model
Description
AM307
Indoor Ambiance Sensor (Temp, Hum, Light, Motion, CO
2
, TVOC, Pressure)
AM308
Indoor Ambiance Sensor (Temp, Hum, Light, Motion, CO
2
, TVOC, Pressure,
PM2.5, PM10)
AM319
Indoor Ambiance Sensor (Temp, Hum, Light, Motion, CO
2
, TVOC, Pressure,
PM2.5, PM10, HCHO/O
3
)
Safety Precautions
Milesight will not shoulder responsibility for any loss or damage resulting from not following the
instructions of this operating guide.

The device must not be disassembled or remodeled in any way.
 In order to protect the security of the device, please change device password when first
configuration. The default password is 123456.

Do not place the device outdoors where the temperature is below/above operating range.
Do not place the device close to objects with naked flames, heat source (oven or sunlight),
cold source, liquid and extreme temperature changes.

The device is not intended to be used as a reference sensor, and Milesight will not should
responsibility for any damage which may result from inaccurate readings.
 The battery should be removed from the device if it is not to be used for an extended period.
Otherwise, the battery might leak and damage the device. Never leave a discharged battery
in the battery compartment.
 Make sure all batteries are newest when install, or battery life will be reduced.

The device must never be subjected to shocks or impacts.
 Do not clean the device with detergents or solvents such as benzene or alcohol. To clean
the device, wipe with a soft moistened cloth. Use another soft, dry cloth to wipe dry.
Declaration of Conformity
AM300 series is in conformity with the essential requirements and other relevant provisions of
the CE, FCC, and RoHS.