Miller Auto-Continuum Drive CE - Section 6 - Maintenance and Troubleshooting; Routine Maintenance

OM-273476 Page 23
SECTION 6 – MAINTENANCE AND TROUBLESHOOTING
6-1. Routine Maintenance
Disconnect power before maintaining.
F
Service equipment more often if used in severe conditions.
ü = Check ◇ = Change m = Clean ¶ = Replace
Every 3
Months
OM-249336 Page 1
OM-249336 Page 1
¶ Unreadable Labels mWeld Terminals ü¶Weld Cords And Cables
 A complete Parts List is available at www.MillerWelds.com
SECTION 6 MAINTENANCE AND TROUBLESHOOTING
Every
3
Months
 Weld Terminals
 Labels
Every
3
Months
6-1. Blowing Out Inside of Unit
804746-B

A complete Parts List is available at www.MillerWelds.com
OM-231242 Page 29
SECTION 17 MAINTENANCE & TROUBLESHOOTING
17-1. Routine Maintenance
Every
3
Months
Replace Cracked
Torch Body
 
Repair Or Replace
Cracked Cables And
Cords
 
Clean
And
Tighten Weld
Connections
 
ümClean And Tighten Weld Connections
¶Damaged Gas Hose
Every 6
Months

Complete Parts List is available at www.MillerWelds.com
OM-278215 Page 33
1/2 in.
(13 mm)
SLUDGE
FUEL
m Inside Unit m Drive Rolls
*To be done by Factory Authorized Service Agent.