OM-248965 Page 44
Z. Gas Flow Error
ERR
GAS
Indicates no gas flow to the gun. The error may be reset by re-establishing gas flow to the gun, and then pressing the Jog/
Purge button.
AA. Robot Communication Error
ROBT
COMM
The robot I/O module has lost communication with the welding power source. Contact factory service department for
assistance.
AB. Network Wait
NET
WAIT
Indicates that the UIM board PC7 is no longer communicating with the PCM board PC4 by DeviceNet.
AC. Cycle Power
CYCL
PWR
Request to cycle power from the welding power source. Turn unit power off and back on again.
AD. PCM Bus Communication
— —
— —
— — Indicates no error message on the displays. PCM board PC4 DeviceNet has gone offline. Turn welding power
source off and back on again to clear the communication error.
AE. RIO Bus Communication
— —
— —
— — Indicates no error message on the displays. RIO DeviceNet is losing packets of data. Turn welding power source off
and back on again to clear the communication error.
AF. Wire Feed Bus Communication
— —
— —
— — Indicates no error message on the displays. WFM board PC6 DeviceNet is losing packets of data. Turn welding
power source off and back on again to clear the communication error.
To Next Page
Loading...
Need help?
General
