OM-289711 Page 11
SECTION 4 – SPECIFICATIONS
F
Please register your product at www.MillerWelds.com/Support/Registration
Specification Digital Infinity Helmet
Viewing Field 4.4 x 3.1 in (112 x 78 mm)
Reaction Time 0.0000400 sec (1/25,000)
Available Shades
All Shades Provide
Continuous UV And
IR Protection.
Weld Mode: Darkened State: No. 8 - No. 13 Light State: No. 3
Cut Mode: Darkened State: No. 5 - No. 8 Light State: No. 3
Grind Mode: Light State: No. 3
X-Mode: Darkened State: No. 8 - No. 13 Light State: No. 3
Sensitivity Control
Adjustable For Vary-
ing Ambient Light
And Welding Arc
Weld Mode: No. 0–No. 10
Cut Mode: No. 0–No. 10
Grind Mode: Not Applicable
X-Mode: No. 0–No. 10
Delay Control
Slows Lens Dark-To-
Light State Between
0.1 And 1.0 Seconds
Weld Mode: No. 0–No. 10
Cut Mode: No. 0–No. 10
Grind Mode: Not Applicable
X-Mode: No. 0–No. 10
Automatic Power Off Shuts Lens Off 45 Minutes After Last Arc Is Struck
Low Battery Light Red Led Illuminates To Indicate 2-3 Days Remaining Battery Life
Power Supply Panasonic CR2450 Lithium Batteries (Miller Part No. 217043)
Sensors Independent/Redundant (Four)
Operating
Temperature
14°F to 131°F / -10°C to +55°C
F
When stored in extremely cold temperatures, warm helmet to
ambient temperature before welding.
Storage Temperature -4°F to 158°F / -20°C to +70°C
F
When stored in extremely cold temperatures, warm helmet to
ambient temperature before welding.
Total Weight 21 oz (598 g)
Standards Meets ANSI Z87.1+ And CSA Z94.3 Standards
Warranty Four Years From Date Of Purchase (Section 13)
To Next Page