Miller Titanium Series - Alarm Control (Titanium 7300 and 9400 Series Helmets)

OM-256 016 Page 17
3-13. Alarm Control (Titanium 7300 And 9400 Series Helmets)
The Alarm emits an audible
signal and the Grind mode
light flashes to alert the oper-
ator at a specific time.
1 Info Control Button
2 Hour +/− Buttons
3 Minute +/− Buttons
4 Save Button
5 Clear Button
6 Exit Button
Timer Procedure
 Press Auto On/Off but-
ton to turn helmet On.
Helmet lens will darken
twice and then clear.
 Press Info button re-
peatedly until Alarm is
displayed on screen.
 Press Hour +/− buttons
to change hour setting.
 Press Minute +/− but-
tons to change minute
setting.
 Press Save button.
 Press the Clear button
to start over, or press
the Exit button if fin-
ished.
 Press external Grind
Mode button or any lens
button to turn off alarm.
1
243
5 6