OM-256 016 Page 21
SECTION 6 − REPLACING THE GRINDING SHIELD OR
LENS COVERS
6-1. Replacing Grinding Shield On 9400i And 1600i Helmets
Ref. 804 109
! Never use the auto-dark-
ening lens without the in-
side and outside lens
covers properly installed.
Welding spatter will dam-
age the auto-darkening
lens and void the
warranty.
1 Grinding Shield
2 Retaining Clip
3 Tab
Rotate both retaining clips to the
Open position.
Gently push shield toward bot-
tom tab and remove shield from
helmet.
Remove retaining clips from
shield. Install clips in same loc-
ation on new shield. (Retaining
clips are not interchangeable.)
Install new shield in helmet and
rotate clips to the Lock position.
Tear-Away Protective Sheets
Tear-away sheets are available
to prolong the life of the griding
shield (see Parts List).
To install tear-away sheets, pull
backing from both sides of the
tear-away, remove white ad-
hesive backing strips, and
place on clear shield.
1
2
3
To Next Page
Loading...
