OM-256 016 Page 22
6-2. Replacing Lens Covers On Quick Release Helmets
! Never use the auto-dark-
ening lens without the in-
side and outside lens
covers properly instal-
led. Welding spatter will
damage the auto-darken-
ing lens and void the war-
ranty.
Outside Lens Cover
1 Lens Holder
2 Release Points
3 Outside Lens Cover
Remove lens holder by press-
ing release points and pulling
the holder away from the hel-
met.
Remove lens cover from hold-
er. Replace lens cover in lens
holder. Reinstall lens holder in
helmet.
Inside Lens Cover
4 Gasket
5 Lens
6 Inside Lens Cover
Remove the inside lens cover
by prying cover from groove in
gasket.
Replace the lens cover by gent-
ly bowing it in the center and in-
serting it, one end at a time, into
the gasket.
Be sure the cover lens is
seated properly (flat) to
prevent fogging.
804 814 / 804 816 / OTOS
1
2
2
3
45 6
To Next Page
Loading...
