MIMAKI CF-1215 User Manual

— 1.27 —
Setting the resolution (GDP) [MODE SET] > [GDP]
Set the resolution of the device to that of your CAD. Refer to the instruction manual for your CAD
for the resolution supported by the CAD.
GDP: Graphic Display Pitch
Set values
0.025 mm : The resolution is set to 0.025 mm.
0.010 mm : The resolution is set to 0.010 mm.
1 Press the
PAGE
+
key several times
until the LCD indicates page 3 of the
LOCAL MENU.
2 Select the [MODE SET].
3 Press the
PAGE
+
key several times
until the LCD indicates page 4 of the
[MODE SET].
4 Set the [GDP] to on of the following.
Press the
F3
+
key to change the se-
lected item alternately.
5 Enter the input values.
Press the
END
key to enter the input
values. If you do not enter the input data,
press the
C E
key.
[ LOCAL ] 1 / 4
TOOL SELECT ———>
CONDITION ———>
TEST CUT ———>
[ LOCAL ] 3 / 4
INTERFACE ———>
MODE SET ———>
SELF TEST ———>
< MODE SET > 1 / 5
Z STROKE ∗7mm >
MULTI–PASS ——— >
VACUUM ∗AutoOFF>
< MODE SET > 4 / 5
OH UNIT ∗INIT val >
ORIGIN ∗CENTER >
GDP ∗0.025 mm >
< MODE SET > 4 / 5
OH UNIT ∗INIT val >
ORIGIN ∗CENTER >
GDP 0.010 mm >
END
[ LOCAL ] 3 / 4
INTERFACE ———>
MODE SET ———>
SELF TEST ———>
F3
+
F2
+
PAGE
+
PAGE
+

MIMAKI CF-1215 Specifications

General

Brand	MIMAKI
Model	CF-1215
Category	Plotter
Language	English