5 Align the tip of the tool to the lower
left point of the desired cutting area.
Move the tool using the jog keys until
the tip of the tool meets the lower left
point (LL) of the cutting area.
Change the head speed or lift/lower ther
tool when necessary.
6 Enter the LL point.
Press the
END
key to enter the input
values. If you do not enter the input data,
press the
C E
key.
The step of procedure 3 will be restored
on the LCD.
7 Move the tool to the current UR point
(upper right).
The coordinates of the UR point in terms
of the command origin are shown on the
LCD.
F3
+
F2
+
F1
+
< CUT AREA > [ mm ]
UPPER RIGHT →
< AREA LL > [ mm ]
–450.0 –300.0
SPEED FAST >
CUTTER UP >
< AREA LL > [ mm ]
–600.0 –450.0
SPEED FAST >
CUTTER UP >
Lower left point (LL)
END
< CUT AREA > [ mm ]
UPPER RIGHT →