19
•Underlined values indicate initial settings.
•What is "setting function"? Setting function is used for setting to match the specifications on the host computer side, or for settings related
to the plotter operation. The content of the setting will remain stored even if the power is shut off.
Interface
BAUD RATE :1200,4800,9600,19200,38400(bps)
DATA ADJ.:7,8(bit)
PARITY :NON, EVEN, ODD
STOP BITS:1,2(bit)
HANDSHAKE :HARD, ENQACK, X-PRM, SOFT
STEP SIZE:0.025, 0.1mm
PARALLEL I/F :NORMAL, BUFFER
CENTER/LOWER RIGHT
ON/OFF
PANEL/HOST
ON/OFF
1.0/0.1
DIVISION CUT :ON/OFF
FRAME CUT :ON/OFF
MARK CUT :ON/OFF
NORMAL/QUALITY/HIGHspd
BAUD RATE : 9600
CUT MODE : NORMAL
CENTER ORIGIN
ROTATION : OFF
DIVISIONCUT : OFF
PRIORITY : PANEL
SHEETSENSOR : OFF
STEP[mm]:1.0
MM/INCH : MM
MM/INCHI
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
EXPAND : OFF
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Cut mode
Origin select
Rotation
Division cut
Priority
Sheet sensor
mm/inch
Expand
Jog step
INTERFACE <ent>
CUT MODE <ent>
ORGN SELECT <ent>
ROTATION <ent>
DIVISIONcut <ent>
PRIORITY <ent>
SHEETsensor <ent>
JOG STEP <ent>
autoCOMMAND <ent>
ENTER
ENTER
Set up reset
SETUP RESET <ent>
MM/INCH <ent>
EXPAND <ent>
Cut sharply
Cut the sheet up to the edge
Rotate characters
Cut in divisions
*
*
*
*
To Next Page
Loading...
Need help?
General
