23
*
No. of copies [No. COPIES]
This function is used to perform cutting of the received data on
two or more sheets.
The device stores the received data in the receiver buffer to
enable cutting in repetition on as many as 999 sheets.
When the device receives new data, the data stored in the
receiver buffer will be updated.
• Setting value (input of numeric data)
1 to 999 (sheets)
• If No. COPIES is executed immediately after
cutting under the remote mode, the data will be
cut overlapped. To avoid this trouble, reset an
origin.
• To send plural pieces of data from the host
computer to the device, the data has to be sent
while providing an interval of 10 seconds or more
after cutting. If two pieces of data are sent from
the host computer to the device within 10 seconds,
the two pieces of data will be subjected to the
plural sheet cutting unless the origin is reset.
• The device cuts division cut data by the specified
number of sheets without dividing the data.
• While performing No. COPIES function, the
device will not receive the data from host
computer.
• In the event that any error appears on the LCD,
refer to page 28.
1. Send the data to be
copied from the
computer, and perform
normal cutting.
2. Press the
REMOTE
key to
switch the Local mode.
3. Set the origing at the
location where copying is
to be done.
4. Press the
FUNCTION
key
several times, select the
[No. COPY].
Press the
ENTER
key once; "1"
flashs.
5. Use the or key to
enter the number of
copies (maximum 999).
6. Press the
ENTER
key,
cutting starts.
"1/10"means "copy being cut/
total number of copies".
After cutting is completed, the
machine goes into remote mode.
CUT1 20 050 0.30
No.COPIES <ENT>
No.COPIES : 1
No.COPIES : 10
* 1/ 10 COPY *
**
REMOTE
**
The origin
at the time
of exeuting
No. COPIES
function.
The origin
at the time of
terminating
No. COPIES
function.
(automatically
estabished).
A
B
Original data
The locations of copies for second
cutting and beyond are to
be allocated according to the size
of the original data.
Lengthwise and widthwise
interval between copies of the
original data is 1 mm.
After the completion
of copying, the location
of origin will be reset.
To Next Page
Loading...
Need help?
General
