MIMAKI JFX200-2513EX - Page 5

5
6
Wipe any ink on the sides of the head and carriage using a clean stick.
• Never rub the nozzle part.
Nozzle part (Never touch)
Clean the side of the
head (dark gray part)
with a clean stick.
Clean using a clean stick.
• Clean the wiper and the bracket until they look like the picture.
• Clean the nozzle surface if the shape of the cap rubber is visible on it.
• If you need to leave your seat during maintenance, press the [ENTER] key to end the cleaning
process. If left as-is, the ink will harden due to the effects of external light, resulting in nozzle
clogging or other harmful effects.
7
Once the cleaning is complete, press the [ENTER] key.
HEAD MAINT.
[ENT]
COMPLETED
Cleaning wiper and cap
• Clean the wiper and the surrounding area twice a week (frequency of cleaning differs depending on the
usage frequency of the printer).
• If there are severe bends or dirt on the wiper, replace it with a new wiper.
"Replacing the wiper"(P. 22)
• When cleaning, make sure no fibers from the clean stick are left behind. Residual fibers may cause the
printing quality to deteriorate.
1
Press the [MAINT.] key in LOCAL.
CARRIAGE OUT
[ENT]