MIMAKI JV33-130BS - Setting Test Draw Arrange

3-50
Setting Test draw arrange
You can set the deployment direction of the test pattern to be printed when performing test printing repeat-
edly.
1
Press the key in the local
mode.
2
Select [MACHINE SETUP] by pressing
the keys.
3
Press the key.
4
Select [STAMP SETUP] by pressing the
keys.
5
Press the key.
6
Select the set value by pressing the
keys.
FEED DIR. : Deployed in the feed (longitudinal) direction of the media (setting at the time of purchase).
SCAN DIR. : Deployed in the scan (crosswise) direction of the media.
Media feed direction
: when the setting value is “FEED DIR.”
: when the setting value is “SCAN DIR.”
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE SE TUP <ENT >
MACH I NE SE TUP
DEODOR I ZE FAN <e n t >
MACH I NE SE TUP
Tes tDr awAr r ange<en t >
Tes tDr awAr r ange .
SETUP :
F EED D I R .