MIMAKI JV33-130BS - Confirming the Heater Temperature

Preparing Heaters
2-19
2
Basic Operations
Reference for the temperature set
Confirming the Heater temperature
1
Press the key on the operation
panel.
• The current Heater temperature is displayed.
2
Press the key at the end of confirmation.
• It returns to the local mode.
Type of media
Glossy chloroeth-
ylene
Tarpaulin FF
Set of the Pre-heater
35°C 35°C 35°C
Set of the Print-heater
35°C 35°C 35°C
Set of the Post-heater
50°C 50°C 50°C
• Adjust it to suitable temperature depending on the media condition.
• When aqueos-color ink is used, no reference for the temperature set is required.
PRE PRT POST
40°C 50°C 35°C