1-10
Connecting cables
Connecting USB2.0 interface cable
Connect the PC and this machine with the USB2.0 inter-
face cable.
Notes on USB 2.0 Interface
When two or more JV33-BS machines are connected to one personal computer
When two or more JV33-BS machines are connected to one personal computer, the personal computer
may not recognize all the JV33-BS machines normally.
Reconnect the unrecognized JV33-BS machine to another USB port, if available, and check to see if it is
recog-nized. If the JV33-BS machine is not recognized by the newly connected USB port, use USB 2.0
repeater cables available on the market.
Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is con-
nected to the same personal computer that a JV33-BS machine is connected to, the USB device may not
be recognized.
When a JV33-BS printer is connected to the personal computer to an externally installed USB hard disk
drive , the data output speed to the JV33-BS machine may drop. That can cause the head unit to stop tem-
porarily at the right or left end during printing.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or
our office when the USB2.0 interface is not
attached to the PC.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
