MIMAKI JV33-130BS - Page 3

ii
Turning the power ON/OFF ................................... 2-4
Turning the power ON .............................................. 2-4
Turning the power OFF ............................................ 2-5
Setting medias ....................................................... 2-6
Useable medias ........................................................ 2-6
Adjusting the head height ......................................... 2-6
Setting a roll media ................................................... 2-8
Take-up device ....................................................... 2-13
Setting leaf media ................................................... 2-14
Changing the printing origin .................................... 2-16
Preparing Heaters ................................................ 2-18
Changing temperature settings of Heater ............... 2-18
Confirming the Heater temperature ........................ 2-19
Test printing ......................................................... 2-20
Test printing ............................................................ 2-20
Head cleaning ......................................................... 2-21
Drawing data ........................................................ 2-22
Starting the print ..................................................... 2-22
Stopping the print temporarily ................................. 2-23
Erasing the received data (Data clear) ................... 2-23
Cutting a media ...................................................... 2-24
CHAPTER 3 Convenient use
User type ................................................................ 3-2
Registering the drawing conditions together
(Type registration) .................................................... 3-2
Registering Type ...................................................... 3-2
Setting media compensation .................................. 3-5
Setting media compensation .................................... 3-5
Changing the set value of Heater .......................... 3-8
Changing temperature settings of Heater ................. 3-8
Adjusting suitable temperature adjustment ............ 3-10
In case the heater temperature is too low .............. 3-11
Setting print mode ................................................ 3-12
Setting of the print quality ....................................... 3-12
Setting scanning direction ...................................... 3-14
Setting Logical-seek ............................................... 3-15
Setting drying time ............................................... 3-16
Setting margins .................................................... 3-17
Setting Priority ...................................................... 3-18
Setting Auto cleaning ........................................... 3-20