5-7
Chapter 5 Troubleshooting
1
2
2
2
5
ERROR 1de
SLIDER PCB V1R2
An error occurred in the power supply of the
slider T PCB.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears,
contact our service desk or your local
distributor to call for service.
ERROR 1e0
SLIDER PCB V3R3
ERROR 1e2
SLIDER PCB V48
ERROR 1e6
PRAM SIZE SHORTAGE
Memory size shortage.
ERROR 201
COMMAND ERROR
The received data is not print data.
Or, an error occurred in the sent print data.
• Execute data clear and send data again.
• Turn off the power and then on again,
and send data again.
• Check the USB cable connection.
• Use a USB cable conforming to the
standard.
ERROR 202
PARAMETER ERROR
An error occurred in the sent print data.
ERROR 206
PRINTING MODE
Print data with unprintable conditions was
received.
• Check the print data output conditions for
RIP software.
• Check the profile.
• If the same error message appears,
contact our service desk or your local
distributor to call for service.
ERROR 304
USB INIT ERR
An error occurred in the USB
communication.
• Check the USB cable connection.
• Reconnect the USB cable.
• Turn off the power and then on again,
and send data again.
• Use a USB cable conforming to the
standard.
ERROR 305
USB TIME OUT
ERROR 401
MOTOR X
An excessive load was applied to the X
motor.
• Check whether the media is set properly
(whether feeding is performed properly).
• Open the cover and check for any
matters that hinder the carriage
operation.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears,?con-
tact our service desk or your local distrib-
utor to call for service.
ERROR 402
MOTOR Y
An excessive load was applied to the Y
motor.
ERROR 403
X CURRENT
An error due to an excessive current of the
X motor was detected.
ERROR 404
Y CURRENT
An error due to an excessive current of the
Y motor was detected.
ERROR 50a
Y ORIGIN
An error occurred in Y origin detection
(initialization operation).
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears, con-
tact our service desk or your local distrib-
utor to call for service.
ERROR 50f
L-SCALE BLACK
Abnormal linear scale.
ERROR 525
WRONG IONIZER
Either the internal circuit has broken or
abnormal discharge occurs.
ERROR 526
IONIZER ION LEVEL
Due to blot on the electrode probe and wear
of it, ion production has decreased.
Use this as a guide for time to take care of
the electrode probe.
• Please clean the electrode probe refer-
ring to the ionizer manual.
• If the status cannot be improved, replace
the relevant electrode probe.
ERROR 527
IONIZER CONDITION
When the ion is absorbed by the
surrounding metal, the instability of
installation environment (temperature,
humidity, peripheral metals, etc.) affects the
performance to remove electricity.
• Please make sure there is no conductor
or another static eliminator in the vicinity
of the ionizer.
• If there is such material, please keep
away from such conductor or another
static eliminator.
ERROR 528
PUMP MOTOR SENSOR
Pump sensor detection error
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears,
contact our service desk or your local
distributor to call for service.
Message Cause Solution
To Next Page
Loading...
