Chapter 1 Before Use
1-13
1
2
2
2
2
Setting ink bottles
1
Take out the ink bottle, and slowly shake it
twenty times and more.
• To prevent ink from leaking when you shake it,
wear gloves and cover the ink bottle cap with a
paper towel etc. Being in that status, slowly shake
it twenty times and more by flowing ink.
2
Remove the cap of the ink bottle.
3
Attach the specialized cap to the ink bottle.
(1) Set the specialized cap on the bottle.
• Before shaking it, check that the cap is firmly
closed.
• If you shake it too strong, it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the
bottle cannot be beaten enough. Tilt the ink bottle
until it becomes vertical.
Cover with paper towel firmly and shake ink slowly
Repeat this
• After the cap is removed, if a seal is attached to
the mouse of the bottle, open the seal using a
cutter knife. When opening the seal, make four
slices (eight sections) as shown in the figure below
and fold the flaps into the bottle.
• Fold the seal flaps fully and firmly into the inside of
the bottle. If they are not sufficiently folded in, ink
supply deficiency could result.
Cut the sheet in eight using a tool
such as a cutter as shown below
and bend securely toward the inside.
To Next Page
Loading...
