MIMAKI UJF-6042 MkII - Setting Event Mail Function

3-20
Chapter 3 Machine setting
10
Press to select a set value, and
press the key.
11
Press the key several times to
end the setting.
Setting event mail function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with “Network
Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://mimaki.com/download/).
Enable the event mail function
1
Press the
(MENU) (>>)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “MAIL
DELIVERY” , and press the key.
4
Press to select “ON”, and press
the key.
5
Press the key several times to
end the setting.
• To reflect network setting, once turn off the power
supply and turn it on again.
• Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.