4-6
Chapter 4 Maintenance
Maintaining the Capping
Station
Maintain the ink cap, wiper, etc. located in the capping
station. (SATION MAINT.)
The ink cap and wiper function as follows.
• Wiper : It wipes off ink sticking to the head nozzles.
• Ink cap : It prevents the head nozzles from clogging due
to dryness.
As the machine is used repeatedly, the wiper and ink cap
gradually become dirty with ink, dust, etc.
If nozzle missing cannot be corrected even after head
cleaning ( P.2-8) has been performed, use a f-200 / lf-
200 Washing Liquid kit and cleaning swab.
Cleaning the Wiper and Cap
It is recommended that the wiper and cap be cleaned
frequently in order to maintain the high image quality of
the machine and keep the machine itself in good working
order.
1
Press the
(MENU)
in LOCAL.
2
Press to select “
MAINTENANCE
”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the key.
• “STATION” will be selected.
4
Press the key.
• “CARRIGE OUT” will be selected and the carriage
will move.
5
Open the right maintenance cover.
6
Remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
7
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket with a
cleaning swab dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance will
not remain.
8
Set the wiper at the original position.
• Insert the wiper by holding the protrusions at its
both ends.
• To keep the nozzle status normal, perform wiper
cleaning frequently.
Tools required for Maintenance
• F-200 / LF-200 Washing Liquid (SPC-0568)
• UJ Cleaning swab
(SPC-0386)
• Gloves • Goggles
• Be sure to wear the supplied goggles and gloves
when maintaining the capping station.Otherwise,
you may get ink in your eyes.
• Do not move the carriage out of the capping
station by hand.When it is desirable to move the
carriage, press the [FUNK1] key to execute the
carriage-out. ( P.4-6Steps 1 to 2)
• Even if you cleaned the wiper, when Nozzle out or
Ink dropping cannot be solved, try to replace the
wiper.
• If the wiper is extremely dirty or has a scratch or
damage on it, replace the wiper(SPA-0271).
( P.4-16 )
To Next Page
Loading...
