MIMAKI UJF-6042 MkII - Setting the Z Origin

3-6
Setting the Z origin
1
Press the
(MENU)
in LOCAL.
2
Press to select “SET ORIGIN” ,
and press the key.
3
Press to select “Z origin” , and
press the key.
4
Press to set the origin position of
Z-axis, and press the key.
5
Press the key several times to
end the setting.
Changing the origin using the JOG
keys
You can also change the origin using the JOG keys.
1
Press keys in local.
• The origin setting mode starts
• A red light pointer mark [ ] is projected on the
table or the media.
2
Press to move the light
pointer mark
• Move the light pointer mark to the position to set a
new origin.
3
Press the key to set the print
origin.
• The origin is changed.
Changing with the “ORIGIN”
in the FUNCTION menu
• The height of the table is also fixed at the same
time. Adjust the height of the table by pressing the
[TABLE-UP][TABLE-DOWN] keys in advance.
• The setting value for the origin set with the JOG
keys is cleared by cutting the power.
• The setting of the table height holds even if turning
off the power.
Changing with the JOG keys