MIMAKI UJF-6042 MkII - Nozzle Wash

4-8
Chapter 4 Maintenance
Nozzle Wash
1
Press the
(MENU)
in LOCAL.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the key.
• “STATION” will be selected.
4
Press , and press the key.
• “NOZZLE WASH” will be selected and the
carriage will move.
5
Open the maintenance cover.
6
Clean the wiper and the bracket, and press
the key.
(1) Open the right maintenance cover then pull out it
by holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
7
Clean the cap rubber , and press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
8
Fill up the cap with cleaning solution for
maintenance．
• Suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
9
Close the maintenance cover, and press
the key.
10
Press to set the time for the
maintenance washing liquid to be left as it
is, and press the key.
• Set value : 1 to 99 minutes (Unit: minute)
• The maintenance washing liquid filled in the cap is
absorbed.
• “Please Wait” will be displayed in the display until
the time you set has elapsed.
Projection
• When nozzle missing is not cleared even after
nozzle recovery ( P.4-13) or this washing is
carried out several times, contact the distributor in
your region or our service office.