3-12
Chapter 3 Setup
Setting of FAN MODE
You can set whether the vacuum function to fix the media
set on the table is performed automatically or you perform
it manually.
The factory default is “AUTOMATIC”.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “FAN MODE” ,
and press the key.
4
Press to select a set value, and
press the key.
• Set value : AUTOMATIC/ MANUAL
5
Press the key several times to
end the setting.
Setting of AUTO CLEANING
Set whether auto-head cleaning is executed or not at the
following intervals before drawing.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “AUTO
CLEANING” , and press the key.
4
Press to select a set value, and
press the key.
• Set value :ON/ OFF
5
Press the key several times to
end the setting.
Setting of PRINT FLUSHING LEVEL
When using a clear acrylic jig and so on, the ink may
splash on the print result as the ink on the nozzles
thickens due to stray light.
If this happens, increase the flushing amount before
printing to prevent ink from splashing.
1
Press the
(MENU)
(3 times)
key in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(<<)
.
3
Press to select “PRINT
FLUSHING” , and press the key.
4
Press to select a set value, and
press the key.
• Set value : Levrel 0 to 3
5
Press the key several times to
end the setting.
• When AUTOMATIC is selected, the fan
automatically starts to operate at print start.
• If you are using the printer in an
environment subject to stray light, select
level 2. Level 2 uses the same
flushing
amount as cleaning.
If the same error still occurs, change the setting to
level 3.
If you can print without problem in level 2 and you
are concerned about the amount of ink
consumed, change the setting to level 1.
• For the amount of ink consumed for each level,
see the following.
Level 0 : 0.003 cc
Level 1 : 0.007 cc
Level 2 : 0.015 cc
Level 3 : 0.024 cc
To Next Page
Loading...
