Chapter 1 Before Use
1-15
1
2
2
2
2
Replace the ink bottle
Perform as follows when [INK END] or [INK NEAR END]
is displayed on the display.
When [INK END] is displayed
1
Move the lever on the tank completely from
the left to the right end.
2
Lift out the ink bottle while keeping it
completely straight.
About IC chip
• The IC chip has information of
ink color, remaining amount of
ink, expiration data, etc.
When setting the ink bottle,
insert the IC chip packed with
the ink bottle into the IC chip
inserting port attached with the
ink cover.
• If you set the IC chip not being
the pair of the ink bottle, image
quality defect etc. may occur.
• The mark indicating color
information is pasted on the IC chip.
IC chip
Mark indication
position
Ink color and indication mark
Ink color Indication mark
Black (one black circle)
Cyan (one blue circle)
Magenta (one red circle)
Yellow (one yellow circle)
White (one white circle)
Clear (two white circles)
Primer (three white circles)
Light cyan (two blue circle)
Light
magenta
(two red circle)
• Be sure to use protective goggles.
• Do not ever rotate the ink bottle at all after setting
it into the tank. Doing so can result in ink leakage.
• Check that the light-blocking cover closes when
removing the ink bottle from the tank. Close by
hand if the cap does not close. Leaving the light-
blocking cover open can result in the ink curing.
• Make sure that the ink is not leaking from the
bottle.
To Next Page
Loading...
