Accutorr 3 Operator's Manual 9-1
9 User Maintenance
CAUTION
Failure of the responsible individual, hospital or institution using this
equipment to implement a satisfactory maintenance schedule may cause
undue equipment failure and possible health hazards.
The safety checks or maintenance involving any disassembly of the equipment
should be performed by professional servicing personnel. Otherwise, undue
equipment failure and possible health hazards could result.
If you discover a problem with any of the equipment, contact your service
personnel or Mindray.
The responsible hospital or institution should carry out all cleaning and
disinfection procedure specified in this chapter.
Do not open the equipment housings. All servicing or upgrades must be carried
out by Mindray trained and authorized personnel.
No modification of this equipment is allowed.
The service personnel must be properly qualified and thoroughly familiar with
the operation of the equipment.
9.1 General Inspection
Before first use, follow these guidelines when inspecting the equipment:
Make sure that the environment and power supply meet the specifications.
Inspect the equipment and its accessories for mechanical damage.
Inspect all power cords for damage, and make sure that their insulation is in good
condition.
Make sure that only specified accessories are applied.
Make sure that the battery meets the performance requirements.
Make sure that the monitor is in good working condition.
In case of any damage or abnormality, do not use the equipment. Contact the hospital’s
biomedical engineers or your service personnel immediately.
9.2 Maintenance and Testing Schedule
The following maintenance and tests, except for visual inspection, power on test, and
battery check, should be carried out by the service personnel only. Ensure the monitor is
safety and performance tested by qualified service personnel before initial installation,
after repair or upgrade or during regularly scheduled maintenance. Contact your service
personnel if any maintenance is required.
Make sure to clean and disinfect (if required) the equipment before any test and
maintenance.