A-2 BeneVision N17/BeneVision N15/BeneVision N12 Patient Monitor Service Manual
A.2.2 Contextual Inspection
Test Item Acceptance Criteria
The enclosure and
accessories
No unusual noises (e.g., a rattle inside the case).
No unusual smells (e.g., burning or smoky smells, particularly from ventilation
holes).
No taped notes that may suggest device deficiencies or operator concerns.
A.3 Device Labelling
Check the labels provided by the manufacturer or the healthcare facility are present and legible.
Main unit label
Integrated warning labels
A.4 Scheduled Electrical Safety Inspection
For scheduled electrical safety inspection, perform all the test items listed in A.6 Electrical Safety
Inspection Test.
A.5 Electrical Safety Inspection after Repair
The following table specifies test items to be performed after the equipment is repaired. Refer to A.6
Electrical Safety Inspection for the description of the test items.
Repair with main unit not disassembled
Test items: 1, 2, 3
Repair with main
unit
disassembled
When neither power supply PCBA nor
patient electrically-connected PCBA is
repaired or replaced
Test items: 1, 2, 3, 4
When power supply PCBA is repaired
or replaced
Test items: 1, 2, 3, 4, 5
When patient electrically-connected
PCBA is repaired or replaced
Test items: 1, 2, 3, 4, 6, 7, 8
When both power supply PCBA and
patient electrically- connected PCBA
are repaired or replaced
Test items: 1, 2, 3, 4, 5, 6, 7, 8
To Next Page
Loading...
Need help?
General
