4 Units Description
4-14
apply some water-proof glue in its circumference when installation.
3. Remove the water-proof glue in the circumference of temperature switch. After replacing
the temperature switch, apply the water-proof glue in its circumference.
4. Remove the water-proof glue in the circumference of radiator, four M4x12 hexagon
socket head screws, radiator and insulation layer in turn, and then replace the
refrigerating plate. You must coat the two sides of the refrigerating plate with
heat-conducting glue (0.1-0.2mm thick) before installing the refrigerating plate; the side
with word is matched with protruding flat. Apply some water-proof glue in the
circumference of radiator after finishing installation.
Precautions
:
1. Proper screws should be used. Stainless screws are required.
2. The insulation layer should be replaced with a new one while maintaining the
refrigerating plate.
3. The refrigerating plate should be installed in the correct direction (the side with words
should be matched with protruding flat), otherwise it can not function as expected.
4. To install the refrigerating plate, the screws must be tightened evenly to avoid the
damage caused by uneven force when mounting the plate
4.3.3.2 Disk Drive Assembly
Figure4-14 Disk Drive Assembly
The disk drive assembly includes the motor assembly, sensor assembly and drive shaft
assembly. The motor assembly and sensor assembly are main parts that need to be
maintained.
To Next Page
Loading...
