Mindray CAL 8000 - Page 57

Installing Your System
3-3
Nonterminal
SM&S Track
Module
100V-240V~
50/60Hz
100VA
Terminal Track
Module
100V-240V~
50/60Hz
100VA
Compressor
a.c. 110V/115V ±10%
60Hz ±2Hz
600VA
a.c. 220V/230V ±10%
50Hz ±2Hz
450VA
60Hz ±2Hz
300VA
3.2.3 General Environment
Working
Environment
Storage
Environment
Operation
Environment
Ambient
Temperature
15℃～32℃
-10℃～40℃
5℃～40℃
Relative Humidity
30%～85%
10%～90%
10%～90%
Atmospheric
Pressure
70kPa～106kPa
50kPa～106kPa
70kPa～106kPa
 The environment shall be as free as possible from dust, mechanical vibrations, loud
noises, and electrical interference.
 It is advisable to evaluate the electromagnetic environment prior to operation of this
system.
 Do not use this system in close proximity to sources of strong electromagnetic radiation
(e.g. unshielded intentional RF sources), as these may interfere with the proper
operation.
 Do not place the system near brush-type motors, flickering fluorescent lights, and
electrical contacts that regularly open and close.
 Do not place the system in direct sunlight or in front of a source of heat or drafts.
 The environment shall be ventilated.
 Do not place the system on a slope.
 Connect only to a properly earth grounded outlet.
 Only use this system indoors.
NOTE
 Only store and use this system in specified environmental conditions.