5-70 Image Optimization
7. Perform rotation and shifting operation to reference line.
8. Save images as necessary.
5.11.13.2 Operation Controls
SCV
Current Quadrant
Tap [A Plane], [B Plane] and [C Plane] to select current active section image.
Reset
Click [All] in Reset field to reset parameters, orientation and zooming status.
CMPR
Trace Options
Line
1. Tap [Line] on the touch screen.
2. Rotate the trackball to place the cursor and press right <Set> key to fix the starting point, rotate the
trackball to extend the line and press right <Set> key again to finish drawing; or you can press left
<Set> key to reset starting point.
Rotate the knob under [Line Extension] on the touch screen to adjust the line length.
3. After line is finished, press left <Set> key to change line position.
Tap [Reset Curve] to cancel current drawing. Press <set> key to display “Cancel” status on the track
ball region, move the track ball to cancel the line.
Trace
1. Tap [Trace] on the touch screen.
2. Rotate the trackball to place the cursor and press right <Set> key to fix the starting point, move the
cursor along the target to trace the outline, and press right <Set> again to finish tracing. During
tracing, press left <Set> to cancel a series of tracing, or you can roll the trackball backwards to
delete latest tracing.
3. After tracing, press left <Set> key to change tracing outline position.
Tap [Reset Curve] to cancel current drawing. Press <set> key to display “Cancel” status on the track
ball region, move the track ball to cancel the trace.
Spline
1. Tap [Spline] on the touch screen.
To Next Page
Loading...
