Mindray Resona I9W - 14 DVR Recording; Send Image

DVR Recording 14-1
14 DVR Recording
NOTE:
Strictly observe the procedures described here to perform the recording and replaying
operations; otherwise it may result in data loss or system malfunction.
Set the PAL or NTSC in the setup and this shall be consistent with that in the DVR.
Accidental exposure to strong electromagnetic fields or mishandling of the video cassette
may result in image and data loss, so check if the recording is successful as soon as
possible. Mindray is not responsible for any data loss.
The system provides built-in DVR recording function. You can use the DVR to record and replay videos
and audios that can be stored in DVD disc or hard disc.
The recorded video is AVI format; you can save it in the hard disk drive, burn to the DVD or export to
the USB disk.
When the built-in DVR is in normal status, the displays at the lower right corner of the screen.
14.1 DVR Recording
After recording, the system will save the recording file automatically, you can select to save in local disk,
U disk or optical disk.
1. Perform ultrasound exams, select appropriate views and adjust parameters to prepare for
recording.
2. Click to open the dialogue box and select desired recording type: Hard disk/USB/CDROM;
3. Click [Close] to enter recording status;
4. Press <F9> to record, and the DVR icon displays as in recording status.
During the recording process, you can perform imaging mode switching, comments adding, body
mark adding and measurements.
5. Press <F9> again to stop recording, the DVR icon in the lower right corner turns into data transfer
status .
 If USB/CDROM is selected, the system sends the recorded file to the target storage media
(USB disk or DVD optical disk drive) in the meantime.
 If Local is selected, the system saves the file to the path: D/LV/DVR.
In the patient task management screen, click [Media Storage Task] tab to check transferring status.
14.2 Send Image
The system also supports exporting recorded images that are saved in the local disk.
1. Click to open the dialogue box, and click [Local Video Management] to enter the managing
dialogue box.
Click [Rename] to rename the video file.
2. Select the destination and the target file, click [Send To] to send the file to the selected path. During
sending progress, the icon displays as .