Safety Precautions 1-7
7. Remove the ultrasound gel from the face of the transducer when the examination
is completed. Water in the gel may enter the acoustic lens and adversely affect
the performance and safety of the transducer.
8. You should properly back up the system to a secure external storage media,
including system configuration, settings and patient data. Data stored to the
system’s hard drive may be lost due to system failure, improper operation or
accident.
9. Do not apply external force to the control panel. Otherwise, the system may be
damaged.
10.
If the system is used in a small room, the room temperature may rise. Please
provide proper ventilation and free air exchange.
11. To dispose of the system or any part, contact Mindray Customer Service
Department or sales representative. Mindray is not responsible for any system
content or accessories that have been discarded improperly. Mindray is not
responsible for any system content or accessories that have been discarded
improperly.
12. Electrical and mechanical performance may be degraded due to long usage
(such as current leakage or distortion and abrasion); the image sensitivity and
precision may become worse too. To ensure optimal system operations, it is
recommended that you maintain the system under a Mindray service agreement.
13. The replaceable fuse is inside the chassis. Refer replacing job to Mindray service
engineers or engineers authorized by Mindray only.
14.
Do not turn OFF the power supply of the system during printing, file storage or
invoking other system operations. An interrupted process may not be
completed, and can become lost or corrupted.
15. The iScape View feature constructs a single extended image from a series of
individual image frames. The quality of the final image is user-dependent and
requires skill to efficiently apply the feature and technique. Exercise caution
when measurements are performed from an iScape View image.
16. Ensure that the current exam date and time are the same as the system date and
time.
17. Use the pluggable power supply as the net power supply breaking facility.
Please read the following precautions carefully to ensure the safety of the patient and the operator
when using the probes.
WARNING:
1. The ultrasonic probe is only for use with the specified ultrasonic
diagnostic system. See Chapter 2.4.2 Probes and Needle-guided
Brackets Available for details.
2.
The ultrasonic probe must be used only by qualified professionals.
3.
Confirm that the transducer and probe cable are normal before and
after each examination. A defective probe may cause electric shock
to the patient.
4.
Do not subject the probe to shock. A defective probe may cause
electric shock to the patient.
5.
Do not disassemble the probe to avoid the possibility of electric
shock.
6.
Never immerse the probe connector into liquids such as water or
disinfectant because the connector is not waterproof. Immersion
may cause electric shock or malfunction.
To Next Page
Loading...
