Mindray Resona I9W - Page 220

5-146 Image Optimization
Tap [Edit] to edit the calipers, and corresponding measurement results changes.
Tap [Hide], and tick measurement tools to be displayed, and the result window will hide results of
unchecked measurement tools.
Add comments and body marks if necessary. For details, refer to chapter “9 Comments and Body
Mark”.
6. Save the cine file. See “6.6 Cine Saving” for details.
5.20.2 3D/4D image data
 VR Mode
1. Select probe and GYN/ pelvic floor exam mode.
2. Enter 3D/4D preparation status, and then acquire 3D/4D image to enter Smart Pelvic.
a) Auto: Select [Pelvic] under the [Smart Scene 3D] scenario, and then press <Update>. The
system enters [Smart Pelvic] tab automatically.
b) Manual: select a non-pelvic subpreset under the [Smart Scene 3D] scenario, press <Update>,
and tap [Smart Pelvic] tab.
3. On image-frozen mode, adjust image parameters.
On 4D imaging mode, if necessary, tap [Timer] to turn on the timer, and freeze the image as
needed.
4. Tap [Auto Measure] to start automatic measurement.
5. If necessary, tap [Edit], points are uniformly distributed on VR image automatically. Roll the
trackball to drag the points. Tap [Edit] again to exit. After editing, tap [Auto Measure] to update the
measurement result.
During the editing, tap [Undo] to undo last operation, and tap [Undo All] to undo all operations.
6. Tap [Rest]/[Valsalva]/[Contraction] to mark current image status.
Tap [Hide] to hide measurement results if necessary.
 CMPR Mode
1. Tap [Multi-plane Mode] on smart pelvic VR mode to enter CMPR mode.
The reference line with an arrow and the other two sampling lines generated by the system are
displayed on the screen. With the reference line being the start line, the three lines correspond to
Open/Closing/Closed images in turn.
2. If necessary, perform the following operations.
 Tap [Ref. Image] to switch between MPRs, and tap [Open]/[Closing]/[Closed] to switch
activated window.
 Tap [Set Ref. Lines] to set the reference line.
 Tap to display the planes in 3*3 mode.
 Rotate the knob under [Line Extension] on the touch screen to adjust the line length.
 Rotate the knob under [Rotate RL] on the touch screen to adjust the line angle.
 Rotate the knob under [Spacing] on the touch screen to adjust the spacing between the three
lines.
 Rotate the knob under [Thickness] on the touch screen to adjust the imaging thickness.
 Rotate the <4D> knob to scroll CMPR image.
 Tap [Auto Measure] to start automatic measurement.
3. Tap [return] to go back to VR mode.
 Parameter Settings