2-16 System Overview
No. Name Description
<19>
Save
E-ink Supported. Set by the user in the Preset.
Supports 3 kinds of save mode:
1. Save single-frame image.
2. Save multi-frame image;
3. Select save mode based on different situations:
a) Real time: Auto cine replay: save multi-frame image
b) Freeze: save single-frame image.
Press to freeze/defreeze the image.
<21>
Print
Press to print the image.
E-ink Supported. Set by the user in the Preset.
<22>
Angle
Rotate to adjust the angle.
Press to switch to the maximum steer angle.
<23>
Bodymark Press to enter or exit Bodymark status.
<24>
ABC Press to enter or exit Comment status.
<25>
Clear
Press to clear in the sequence of “the selected measurement and
comment information”, “screen information of the current application
mode”, and then “all measurement and comment information”
Long press to clear all the measurement and comment information
on the screen.
<26>
Cursor Press to display/hide the cursor.
<27>
/ Set key. The function is determined based on the actual situation. For
example, next one or previous one; or special command of some special
modes.
<28>
/
<29>
Measure
Press to enter/exit the application measurement mode, and start default
measurement.
<30>
Caliper
Press to enter/exit the general measurement mode, and start default
measurement.
<31>
Update
Switch the current active window in multi-windows mode.
Complete the image acquisition in iScape View/3D/4D mode etc..
<32>
/
Move the trackball to change the cursor position or repaly multi-
frame image.
Adjust or move the VOI.
Move the comment or body mark.
Adjust the probe orientation of the body mark
<33>
/
Battery indicator: displays the battery indicator
NOTE: Available only after the battery assembly is configured.
Tip: “/” means the key / knob has no silk-printed name.
To Next Page
Loading...
