Mindray Resona I9W - Page 391

EMC Guidance and Manufacturer’s Declaration 16-3
TABLE 1
GUIDANCE AND MINDRAY DECLARATION—ELECTROMAGNETIC EMISSIONS
The system is intended for use in the electromagnetic environment specified below. The customer
or the user of system should assure that it is used in such an environment.
EMISSIONS TEST COMPLIANCE
ELECTROMAGNETIC ENVIROMENT –
GUIDANCE
RF Emissions
CISPR 11
Group 1
The system uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
The system is suitable for use in all
establishments
including domestic establishments and those directly
connected to the public low
-
voltage power supply
network that supplies buildings used for domestic
purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
Compliance
TABLE 2
GUIDANCE AND MINDRAY DECLARATION—ELECTROMAGNETIC EMISSIONS
The Probe P7-3Ts/P7-3TE/P7-3TU and Fusion imaging function which integrated in the system is
intended for use in the electromagnetic environment specified below. The customer or the user of
system should assure that it is used in such an environment.
EMISSIONS TEST COMPLIANCE
ELECTROMAGNETIC ENVIROMENT –
GUIDANCE
RF Emissions
CISPR 11
Group 1
The system uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class A
The system is suitable for use in all establishments
other than
domestic and those directly connected to the
public low
-voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
Compliance