Calculations Options
The following categories of calculations are launched with Presets. Users may select other
categories to measure during the exam using the Softkey OLED controls or onscreen Menu lists.
Abdomen - used for measuring abdominal organs (liver, gall bladder, pancreas and kidney,
etc.) and large abdominal vessels.
OB - used for measuring fetal growth indices (including EFW) as well as GA and EDD
calculations. The fetus can be evaluated through growth graph analysis and the fetal
biophysical profile.
Cardiac - used for left ventricle function measurements and measuring chambers, main artery
and vein parameters, etc.
Gynecology - used for the uterus, ovary and follicles, etc.
Urology – used for the prostate, bladder and kidneys
Small Part - used for small parts such as the thyroid, scrotum or breast.
Pediatrics - used for hip joint measurement, and abdominal and pelvic organs
Vascular - used for carotid, cerebral, transcranial, upper and lower extremities vessels, etc.
Smart OB Measurement
There is an auto measurement method for commonly-used OB measurement items
(HC/BPD/OFD/AC/FL/NT).
The system can fix the caliper of Smart OB measurements automatically according to the feature
of the 2D or 3D/4D scanning image. Caliper position may be fine-tuned after system has provided
data, according to the actual situation.
Configuration
Smart OB is a purchased license. Please confirm Smart OB has been configured before use.
Operations are as follows:
1. Press <Service> key to enter User Diagnostics Panel interface.
2. Click [License Info] to enter License Information interface, and check if Smart OB is
displayed on Features list.
Once configured, Smart OB is measured by entering presets listed under the OB exam type.
Smart OB is available on the convex transducer under OB exam mode.
Basic Procedures for Smart OB measurements
1. Press <New patient> key to start a new patient; input LMP information.
2. Select the proper probe and exam type. Perform 2D or 3D/4D scanning mode to locate the
appropriate region.
3. Press <Calc> key to enter measurement mode, the image will be frozen.
4. Select Smart OB (HC/BPD/OFD/AC/FL/NT) measurements, the system fixes the measure
caliper automatically. Caliper position may be modified after data is displayed according to
the actual situation.
5. After Smart OB measurements are done, the result window will display the related data at
the lower right corner of the screen.
To Next Page
Loading...
Need help?
General
