14 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
a. Place the motor in the deployed position.
b. Locate the i-Pilot Link cable, at the base of the
Control Head.
Control HeadControl Head
Coil CordCoil Cord
MountMount
i-Pilot i-Pilot
LinkLink
CAUTION
Not following the recommended wire routing for the i-Pilot
Link cable, if equipped, may cause damage to the product
and void your product warranty. Route cables away from
pinch points or other areas that may cause them to bend
in sharp angles. Routing the cables in any way other than
directed may cause damage to the cables by being pinched
or severed.
1
c. The i-Pilot Link cable should be fed all the way
through the Coil Cord. It should exit the Coil Cord
at the bottom of the Coil Cord, where it connects to
the Mount.
NOTICE: After the i-Pilot Link Cable exits the Coil Cord,
it should be routed through an established routing system
on the boat, in an area with minimal interference. Inspect
the selected route carefully to ensure that there are no
sharp edges, obstacles, or obstructions that may damage
the cables.
ROUTING THE i-PILOT LINK CABLE
To Next Page
Loading...
