16
GETTING UP AND RUNNING
Installing and removing a memory card
Insert the memory card all the way into the card slot and then
release (3). The card should catch in the slot.
• Insert the card so the face is toward the front of the camera.
Always push the card in straight, never at an angle. Never force
the card. If the card does not fit, check that it is orientated
correctly.
• If a MultiMediaCard is inserted incorrectly, it will lock, but the
card chamber door will not close.
To eject a memory card, press the card into the slot and release
(4). The card can now be pulled out.
Close the battery-chamber door (5) and slide it toward the top of
the camera to engage the safety catch (6).
Slide the battery-chamber door toward the bottom of the camera
to release the safety catch (1). Open the door (2).
An SD (Secure Digital) Memory card or MultiMediaCard must be
inserted for the camera to operate. If a card has not been inserted,
a no-card warning will appear on the LCD monitor; the shutter can
still be released.
Always turn off the camera and confirm the indicator lamp is not orange
and blinking before changing the memory card, otherwise the card may be
damaged, and data lost.
1
2
4
6
3
5
To Next Page
Loading...
Need help?
General
