1.Disconnect the USB cable.
2.Turn off the camera.
3.Change the memory card.
4.Reconnect the USB cable.
5.Turn on the camera to remake the
USB connection.
71
Changing the memory card - data-transfer mode
Care should be taken when changing memory cards while the camera is attached to a computer.
Data could be lost or damaged if the camera is not disconnected properly.
Windows Me, 2000 professional, and XP
Macintosh
1.Stop the USB connection using the unplug-or-eject-hardware routine (p. 74).
2.Disconnect the USB cable.
3.Turn off the camera.
4.Change the memory card.
5.Reconnect the USB cable.
6.Turn on the camera to remake the USB connection.
1. Stop the USB connection by dragging the drive icon into the trash (p. 75).
2. Disconnect the USB cable.
3. Turn off the camera.
4. Change the memory card.
5. Reconnect the USB cable.
6. Turn on the camera to remake the USB connection.
Windows 98 and 98SE
Never remove the USB
cable while the viewfinder
indicator lamp is lit!
To Next Page
Loading...
