Minolta EP1085 - Add Paper Indicator; Adding Paper (Drawer)

5
When an Indicator Lights Up
5-4 EP1085
Add Paper Indicator
When the Drawer or the Multi Bypass
Tray has run out of paper, the Add
Paper Indicator lights up. At this time,
you cannot start a new copy cycle
Use the following procedure to load
paper into the Drawer or the Multi
Bypass Tray.
Adding Paper (Drawer)
1 Slide out the Drawer and press
down the Paper Lifting Plate.
2 Slide out the Edge Guides in the
direction of the arrows.
3 Load the paper stack into the
Drawer so that its front side faces
down. Make sure that the paper
stack rests under the two catches of
the Drawer.
NOTE
è The paper should be loaded no
higher than the Ä (Max. Level
Indicator) on the Edge Guide.
1139O3
1142O017AA
Monitor Display
Add Paper Indicator