● Hold down the S/A/H button to display the average of the memory data
on the digital display and on the pointer of the analog scale (L).
E47
Special Functions
<Display example>
While the S/A/H button is held down:
Special Functions
E46
Average exposure
For spot measurement, the meter calculates the average of the maximum
and minimum measurements stored in memory.
For incident light measurement, the meter calculates an average exposure
from up to ten measurements stored in memory.
Number of values in
memory
Aperture for averaged
exposure
1
Take measurements of up
to ten points on the
subject, including highlight
and shadow areas, and
store the measurement
data in memory.
2
Set the calculation mode to
“A” with the up/down dial
while pressing the S/A/H
button.
● When the incident light
measurement is selected, the
calculation mode is
automatically set to “A”. (It
cannot be set to “S” or “H”.)
A measured value cannot be
used for the average exposure
calculation unless it has been
stored in memory.
● If there is no value in memory and the current measurement value is
displayed on the digital readout: the measurement value is stored in
memory and used in average exposure calculations.
● If there is no value in memory and no reading on the digital readout:
no exposure value is calculated.
flashmetervieng.qx3302.12.259:21PMページ46
To Next Page
Loading...
Need help?
General
