Minolta FLASH METER VI User Manual

Basic Operation
E21
Basic Operation
E20
Insert a battery (p. 9)
↓
Set film speed (p. 12)
1. With a still camera
Measuring ambient light
1
Prepare the meter to start
taking readings.
2
Press the MODE button to
switch the mode display to
AMBI.
● Changing the measuring mode
retains the memory data but
clears previous measurement
data.
3
Specify the desired shutter
speed with the up/down
dial.
● Shutter speed can be set within
the range of 30 min. to 1/16000
sec.
● Turning the up/down dial
upward increases the shutter
speed. Turning it downward
lowers the shutter speed.
● The shutter speed can also be
changed after meter readings.
4
Press the measuring
button to take readings.
● The meter takes measurements
continuously as you hold down the
incident light measuring button. The
digital display on the data panel
displays the measurement data. At
the same time, the measurement
data are also displayed on the dot
indicator of the analog scale L.
When the measuring button is
released, the meter stops taking
measurements and displays only
the latest measurement result.
● The meter takes measurements
continuously as you hold down the
spot measuring button. The digital
display in the viewfinder displays
the measurement data. At the same
time, the measurement data are
also displayed on the dot indicator
of the analog scale R. When the
measuring button is released, the
meter stops taking measurements.
The latest measurement result
appears on the digital display of the
external data panel and on the dot
indicator of the analog scale R
display.
● Pressing the CLR button
clears the measurement data.
Spot measuring
button
Incident light
measuring button
flashmetervieng.qx3302.12.259:21PMページ20

Minolta FLASH METER VI Specifications

General

Brand	Minolta
Model	FLASH METER VI
Category	Measuring Instruments
Language	English