Minolta FLASH METER VI User Manual

E75E74
Care and Storage
1. Care
1) If the meter gets dirty, it can be wiped with a soft, dry cloth. Do not use
solvents such as thinners or benzene at all.
2) If the Spherical Diffuser becomes stained, remove it from the meter,
wash the diffuser carefully in water with amild detergent, and rinse and
dry the diffuser thoroughly before reattaching it to the meter.
3) Never attempt to disassemble the meter if it becomes damaged or
faulty. Please contact a Minolta Service Facility.
2. Storage
1) The meter should not be stored in areas where it may be subject to
temperatures higher than 55°C (131°F) or lower than -20°C (-4°F), or in
areas subject to high humidity. It is recommended that the meter be
stored in an airtight container together with a drying agent such as silica
gel.
2) Do not leave the meter in places such as the rear window or trunk of a
car, otherwise it will get extremely hot, resulting in damage.
3) Remove the battery whenever the meter is left unused for more than 2
weeks, to avoid the risk of damage due to battery leakage.
Sync. Cord III
This is a 5-meter long cord that
connects together the Flash Meter
VI, flash unit and camera’s sync
terminal. Using this cord, you can
take flash exposure readings by
simply releasing the shutter,
without changing any connections.
Common accessories
Accessories
Flat Diffuser
With this diffuser attached, the
Flash Meter VI can be used to
measure lighting contrast (ratio of
brightness) and exposure for flat
subjects.
Item Condition
4X Spherical ND Diffuser Set exposure correction to +2.0Ev.
8X Spherical ND Diffuser Set exposure correction to +3.0Ev.
Spot Mask Nothing particular
★ Only the accessories shown above may be used with the Flash Meter
VI.
flashmetervieng.qx3302.12.259:21PMページ74

Minolta FLASH METER VI Specifications

General

Brand	Minolta
Model	FLASH METER VI
Category	Measuring Instruments
Language	English