E73
Special Functions
E72
Special Functions
TIME display CINE display
Reference: How to reset to initial settings
You can reset various settings changed in custom setting mode to their
initial values (default factory settings).
1. Turn the power on.
2. Hold down the POWER button for approx. 2 sec. while pressing the CLR
button.
◆ The power turns off and the default settings are restored.
The shutter speed is set to 1/60 sec. Both the film speed and instant
film speed are set to ISO 100. The measurement data and memory
data are cleared.
5) TIME/CINE setting
Switches between shutter speed and framing-rate in AMBI mode Note
that it is not possible to switch to another measuring mode (CORD or
NON CORD) while the framing-rate setting is active.
1
Turn the power on while
pressing the MODE button,
or press the MODE button
while in Alt mode.
2
Turn the up/down dial to
set the shutter-speed or
framing-rate value you
desire.
● Select either TIME or CINE
mode.
flashmetervieng.qx3302.12.259:21PMページ72
To Next Page
Loading...
Need help?
General
